Terry's Tid Bits II

[dawson_fire]

Rounding out my shots from Hazle Twp. are this 95' Aerialscope and their KME rescue.

Terry

[dawson_fire]

The Hazleton Fire Dept. runs this KME rearmount.

Terry

[dawson_fire]

On our way to Maine for vacation we passed through Newtown-Sandy Hook Connecticut where one of the worst massacres in our country took place.Newtown runs this Pierce engine 2000/1000 which is set up for water supply with 130' of hard sleeves in various lengths and a large amount of 5" hose.

Terry

[dawson_fire]

Newtown runs this Pierce Dash 105' aerial with All-Steer.

Terry

[dawson_fire]

Newtown runs this IH/Pierce.

Terry

[dawson_fire]

Newtown runs this Spartan/Pierce which started with the Cheshire,Conn. fire co as a Maxim/Pierce any additional info would be appreciated.

Terry

[e11ramfireman]

Newtown runs this Spartan/Pierce which started with the Cheshire,Conn. fire co as a Maxim/Pierce any additional info would be appreciated.

Terry

When in Cheshire it was on a Maxim F, don't recall exactly the year but believe it was a 1976.  I am not sure if the body is a 76 or was done later on.  I believe Cheshire parted with it around 2004 and Gowans Knight (local small fire apparatus builder in CT) remounted the body for Newtown shortly after.

[dawson_fire]

Sandy Hook,Connecticut runs this Pierce Arrow XT pumper.

Terry

[dawson_fire]

Sandy Hook also runs this Spartan/Rescue 1(?) and a picture of a plague on the station wall with the names of the 26 people who lost their lives in the shooting which was at the school behind the station. They also have 26 stars on the roof of the station.

Terry

[dawson_fire]

Found this Duplex/Pierce along the road in Maine marked for Swan Island. Originally it was slime lime and I think it has a look like it might have come from Long Island job#E-0791

Terry

[GA_Dave]

Found this Duplex/Pierce along the road in Maine marked for Swan Island. Originally it was slime lime and I think it has a look like it might have come from Long Island job#E-0791

Terry

Original to Cohanzie FC #5, Waterford, CT. It's a 1980 Duplex D-300/Pierce 2000/500.

[dawson_fire]

Found this Duplex/Pierce along the road in Maine marked for Swan Island. Originally it was slime lime and I think it has a look like it might have come from Long Island job#E-0791

Terry

Original to Cohanzie FC #5, Waterford, CT.  It's a 1980 Duplex D-300/Pierce 2000/500.

Thanks Dave!  Looks like you had a good time in North Carolina and Virginia!

Terry

[GA_Dave]

Thanks Dave!  Looks like you had a good time in North Carolina and Virginia!

Terry

I did! Wait until you see the stuff from my July/August trip up north!

[dawson_fire]

Thanks Dave!  Looks like you had a good time in North Carolina and Virginia!

Terry

I did!  Wait until you see the stuff from my July/August trip up north!

Where did you go up north? I made to Maine and a few states between here and there...

Terry

[GA_Dave]

Where did you go up north? I made to Maine and a few states between here and there...

Terry

I went to an event called Fire Fest in Meriden, CT, followed by a couple days of shooting in CT and MA, then over to eastern PA for ten days that included one in NJ, then to the SPAAMFAA meet in NJ. The trip totaled 22 days and 3600+ miles and I shot about 300 rigs.

[dawson_fire]

Where did you go up north? I made to Maine and a few states between here and there...

Terry

I went to an event called Fire Fest in Meriden, CT, followed by a couple days of shooting in CT and MA, then over to eastern PA for ten days that included one in NJ, then to the SPAAMFAA meet in NJ.  The trip totaled 22 days and 3600+ miles and I shot about 300 rigs.

Sounds like a good time!

Terry

[dawson_fire]

Belfast,Maine has this Seagrave 100' rearmount for sale which has been kept outside for some time.

Terry

[dawson_fire]

Liberty,Maine once ran this Ford/General Safety Tele-Squirt which came from Minnesota (no other info) It has been replaced with an E\-One.

Terry

[dawson_fire]

Bar Harbor, Maine runs this IH/Metalfab tanker and once ran this Ferrara 1250/500 75' as Ladder 4.I think the numbers are correct but corrections are welcome.

Terry

[dawson_fire]

Bar Harbor's new Ladder 4 is this 2018 E\-One 2000/500 75' quint.

Terry